Proper study guides for Regenerate Cisco Designing Cisco Wireless Enterprise Networks certified begins with Cisco 300-360 preparation products which designed to deliver the Printable 300-360 questions by making you pass the 300-360 test at your first time. Try the free 300-360 demo right now.


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 300-360 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-360 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/300-360-exam-dumps.html

Q31. Which list of characteristics must all controllers in a mobility group have in common based on best practices?

A. mobility group name, version of controller code, Control and Provisioning of Wireless Access Points mode,ACLs, and WLANs (SSIDs)

B. mobility domain name, version of controller code, and Control and Provisioning of Wireless Access Pointsmode

C. mobility domain name, version of controller code, Control and Provisioning of Wireless Access Pointsmode, ACLs, and WLANs (SSIDs)

D. mobility group name, version of controller code, and Control and Provisioning of Wireless Access Pointsmode

Answer: A


Q32. While performing a Layer 1 passive wireless site survey of a location an engineer detects several instances of low power frequency hopping interference, but cannot physically locate the interfering device or devices. Why is the engineer unable to locate the offending device or devices?

A. The sources are nearby narrow-beam radar and are sweeping through the facility.

B. The sources are PAN and are mobile.

C. The sources are above the ceiling file and transmit intermittently.

D. The sources are actually high-powered devices and transmit from off the site.

Answer: B


Q33. An engineer is deploying an outdoor Mesh network. Which four major factors should be considered? (Choose four.)

A. power

B. buildings

C. traffic lights

D. satellite dishes

E. line of sight

F. network connectivity

G. power lines

H. mounting

Answer: A,E,F,H


Q34. Cisco 7925G phones are experiencing intermittent connectivity issues. The wireless survey reveals that the facility has no current coverage holes. The radios on the 2.4GHz channel have all been statically set to power level 1. Which two reasons could explain why the phones are having issues on this wireless network? (Choose two.)

A. The phones are experiencing excessive co-channel interference.

B. The phones only operate on the 2.4 GHz band when the power level is above 25 mW.

C. The phones are not transmitting at the same power levels as the access points.

D. The phones are experiencing delays of less than 30 ms within their coverage cell.

E. The phones are receiving greater than -67 dBm RSSI on the 2.4 GHz band.

Answer: A,C


Q35. An engineer is configuring an autonomous AP for RADIUS authentication. What three pieces of information must be known to configure the AP? (Choose three.)

A. BVI IP address

B. group name

C. RADIUS IP address

D. PAC encryption key

E. username and password

F. shared secret

Answer: A,C,F


Q36. A hospital environment was designed to guarantee RF coverage at or better than -67 dBm in the 5 GHz spectrum. The customer mandates that RRM be used for DCA and TPC in both bands. After deployment, why do many of the legacy 802.11b/g devices have difficulty maintaining connectivity?

A. Excessive co-channel interference in the 2.4 GHz band exists.

B. Excessive overlapping channels in the 2.4 GHz band exists.

C. TPC drastically reduces Tx power in the 2.4 GHz band.

D. TCP drastically increases Tx power in the 2.4 GHz band.

Answer: C