H12-211 Exam Questions and Answers are updated and H12-211 Dumps are verified by experts. Once you have completely prepared with our H12-211 Exam Questions you will be ready for the real H12-211 exam without a problem. We have H12-211 Dumps Questions. PASSED H12-211 Braindumps First attempt! Here What I Did.

Online H12-211 free questions and answers of New Version:

NEW QUESTION 1
Interface G0/0/1 on RTA contains a MAC address of 00e0-fc03-aa73 and is configured with the IPv6 address2001::2E0:FCFF:FE03:AA73. Which method is most likely to have been used to configure the interface IPv6address?

  • A. DHCPv6
  • B. Auto-link
  • C. ARP
  • D. EUI-64

Answer: D

NEW QUESTION 2
A DHCP server in the enterprise network is being used to allocated IP addresses to hosts. An administratordiscovers however that some hosts are obtaining IP addresses outside of the scope of the DHCP server’saddress pool. What are the possible reasons for this?(Choose three).

  • A. Another DHCP server exists in the network and is allocating IP addresses to hosts that happen to be withina closer proximity than the authorized DHCP server
  • B. The hosts were unable to discover a DHCP server and therefore generated their own address in the169.254.0.0 address range.
  • C. The hosts were unable to discover a DHCP server and therefore generated their own address in the127.254.0.0 address range.
  • D. All addresses from the DHCP pool have been assigned

Answer: ABD

NEW QUESTION 3
Which of the following statements regarding static and dynamic routing is incorrect?

  • A. The static route can be easily configured and managed on the enterprise network.
  • B. The use of dynamic routing is more convenient for the administrator to manage the network following network convergence.
  • C. The static route can automatically recover when a link failure is encountered.
  • D. Dynamic routing will use more resources than static routes.

Answer: C

NEW QUESTION 4
Which of the following OSPF versions is specific to IPv6?

  • A. OSPFv1
  • B. OSPFv2
  • C. OSPFv3
  • D. OSPFv4

Answer: C

NEW QUESTION 5
The administrator has configured an IP address for Host A and Host B, but had forgotten to configure a defaultgateway. What effect will this have on the hosts?

  • A. Neither host will be affected, and therefore will be able to communicate with the peer.
  • B. Host A will be unable to connect to the router’s G0/0/0 interface.
  • C. Hosts will be unable to comminicate unless arp-proxy is enabled on the router.
  • D. The host will be unable to reach neither the local nor remote network destinations .

Answer: C

NEW QUESTION 6
The administrator cannot use telnet to manage the AR2200. The administrator is able to verify connectivity tothe router and has been informed that other administrators have no difficulties using telnet. Which statementsdescribe the possible reasons for this problem?(Choose two)

  • A. The user’s status has been blocked
  • B. The user’s priviledge level has been changed to 0.
  • C. The user has been deleted.
  • D. The telnet service in the AR2200 router has been disabled.

Answer: AC

NEW QUESTION 7
The administrator uses the ping command on the host to test connectivity to the website www.huawei.com.
The command line shows a request time out. The administrator displays the ARP entries for the host.
Which entry will be found in the ARP cache table of the host?

  • A. The MAC address of the destination www.huawei.com will exist in the ARP cache.
  • B. The MAC address of the switch will exist in the ARP cache.
  • C. The IP address of the destination www.huawei.com will exist in the ARP cache.
  • D. The MAC address of router interface G0/0/0, will exist in the ARP cache.

Answer: D

NEW QUESTION 8
Which of the following statements about the information contained in a Database Description packet are true?(Choose three)

  • A. A Database Description packet contains all information about each LSA.
  • B. A Database Description packet contains only the header of an LSA.
  • C. The header of an LSA is the unique identifier of the LSA.
  • D. The header of an LSA is only a small portion of all the data of the LSA.

Answer: BCD

NEW QUESTION 9
Which of the following statements regarding single area OSPF are correct?(Choose three)

  • A. An IP address needs to be configured on a loopback interface of each router before configuring an OSPFarea.
  • B. The value of an area can be from 0.0.0.0 to 255.255.255.255.
  • C. A single area can be configured using any supported area number.
  • D. All of the links of the network need to be advertised in Area 0.

Answer: BCD

NEW QUESTION 10
According to OSI reference model, which layer is responsible for end to end error checking and flow control?

  • A. Physical layer
  • B. Data link layer
  • C. Network layer
  • D. Transport layer

Answer: D

NEW QUESTION 11
Refer to the graphic. RTA and RTB are connected over a Frame Relay network using a DLCI, as shown. Staticmapping is required on RTA. Which of the following commands will achieve this?

  • A. [RTA-Serial1/0/1]fr map ip 172.16.1.1 30
  • B. [RTA-Serial1/0/1]fr map ip 172.16.1.1 31
  • C. [RTA-Serial1/0/1]fr map ip 172.16.2.1 30
  • D. [RTA-Serial1/0/1]fr map ip 172.16.2.1 31

Answer: C

NEW QUESTION 12
Two end stations in a point-to-point network perform address resolution. Which of the following statements iscorrect?

  • A. The destination address of an ARP request from each station will be a unicast MAC address.
  • B. The destination address of an ARP request from each station will be a broadcast IP address.
  • C. The destination address of an ARP reply from each station will be a unicast MAC address
  • D. The destination address of an ARP reply from each station will be a broadcast MAC address.

Answer: C

NEW QUESTION 13
What is the maximum number of member interfaces supported by a single Eth-Trunk?

  • A. 6.
  • B. 8.
  • C. 10
  • D. 12.

Answer: B

NEW QUESTION 14
An administrator currently manages AR2200 devices in the network through a single password, however thecompany wishes to introduce another two administrators and provide unique user credentials and privilegelevels for telnet access to the network devices. What action can be taken?(Choose three)

  • A. Configure three users under the AAA-view, and assign each a different password.
  • B. The authentication mode must be changed to AAA.
  • C. Each administrator must be assigned a privilege level.
  • D. A public IP address must be assigned to each user for telnet access

Answer: ABC

NEW QUESTION 15
The network administrator wants to improve the performance of network transmission, what steps can theadministrator take?(Choose two)

  • A. Change the work mode to full duplex of each end station.
  • B. Link the end stations together using a switch.
  • C. Change the work mode to half duplex of each end station.
  • D. Link the end stations together using a hub.

Answer: AB

NEW QUESTION 16
After a command for displaying RIP route information is entered on a router, peer 192.168.1.2 on Serial1/0/0 isdisplayed in the returned result. What does 192.168.1.2 stand for?

  • A. Address of a RIP neighbor
  • B. Address of the port with the RIP protocol enabled
  • C. Next hop address of the RIP route
  • D. Transmission address of the RIP protocol

Answer: A

NEW QUESTION 17
Which of the following applications can be used to detect the path along which the data packets aretransmitted from the source to the destination?
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">

  • A. Route
  • B. Netstat
  • C. Tracert
  • D. Send

Answer: C

NEW QUESTION 18
Whilst configuring a device, an administrator experiences trouble remembering certain commands. Which of the following will help support the administrator?(Choose two)

  • A. TAB
  • B. questionmark
  • C. ctrl+b
  • D. ctrl+c

Answer: AB

P.S. 2passeasy now are offering 100% pass ensure H12-211 dumps! All H12-211 exam questions have been updated with correct answers: https://www.2passeasy.com/dumps/H12-211/ (233 New Questions)