Proper study guides for H12-211 Huawei Certified Datacom Associate-Huawei Networking Technology and Device (HCDA-HNTD) certified begins with H12-211 Study Guides preparation products which designed to deliver the H12-211 Braindumps by making you pass the H12-211 test at your first time. Try the free H12-211 Dumps Questions right now.

Check H12-211 free dumps before getting the full version:

NEW QUESTION 1
When both ends running PPP protocol detect that the physical link is active, the link state will transit from deadto establish. Which of the following protocols is used to negotiate the link parameters during this phase?

  • A. IP
  • B. DHCP
  • C. LCP
  • D. NCP

Answer: C

NEW QUESTION 2
Which of the following commands can be used to view the current configurations on a Huawei router?

  • A. display current-configuration
  • B. display saved-configuration
  • C. view saved-configuration
  • D. show startup-configuration

Answer: A

NEW QUESTION 3
Refer to the graphic. RTA and RTB have established a GRE tunnel, but only RTA has enabled the keepalivefunction. When RTB receive a keepalive message from RTA, how will RTB respond?

  • A. RTB will discard the keepalive message.
  • B. RTB willl record receipt of the keepalive message but won’t reply
  • C. RTB will send a keepalive in response.
  • D. RTB will send a keepalive reply and begin to actively send keepalive messages.

Answer: C

NEW QUESTION 4
On Huawei switch, which of the following commands can be used to set port duplex mode as"autonegotiation"?(Choose two)

  • A. duplex negotiation auto
  • B. duplex auto-negotiation
  • C. duplex auto
  • D. undo duplex

Answer: CD

NEW QUESTION 5
Which of the following problems are caused by routing loops?(Choose three)

  • A. Slow convergence
  • B. Packets circulate between routers
  • C. Router restarting
  • D. Inconsistency of routing information

Answer: ABD

NEW QUESTION 6
What are the three protocol components defined by PPP?(Choose three).

  • A. Data encapsulation.
  • B. LCP
  • C. NCP
  • D. IPCP

Answer: ABC

NEW QUESTION 7
Which of the following statements about collision domains and broadcast domains are correct?(Choose three)

  • A. Devices connected to the same hub form a collision domain
  • B. Devices connected to the same hub form a broadcast domain
  • C. Devices connected to the same bridge form a collision domain
  • D. Devices connected to the same bridge form a broadcast domain
  • E. Devices connected to the same router form a broadcast domain

Answer: ABD

NEW QUESTION 8
The Eth-Trunk frame forwarding mechanism used to prevent changes in the data sequence forwards framesbased on which of the following parameters?

  • A. The same source or destination IP address
  • B. The same source or destination MAC address.
  • C. The same protocol type.
  • D. The same source or destination port number.

Answer: AB

NEW QUESTION 9
Refer to the graphic. RTA is a PPPoE client, and following transmission of PADI, Server A responds withPADO packets to RTA. Which distribution method is used for sending PADO packets?

  • A. unicast
  • B. multicast
  • C. broadcast
  • D. anycast

Answer: A

NEW QUESTION 10
[RTA]aaa
[RTA-aaa]domain huawei
[RTA-aaa-domain-huawei]authentication-scheme au1 [RTA-aaa-domain-huawei]authentication-scheme au2
Refer to the configuration output. RTA has been configured using AAA as shown, and associated with the“huawei” domain. For users in the huawei domain, which authentication- scheme will be used

  • A. au1
  • B. au2
  • C. au1 will be use
  • D. When au1 is deleted, users will use au2
  • E. au2 will be use
  • F. When au2 is deleted, users will use au1

Answer: B

NEW QUESTION 11
If PPP authentication fails, which type of packet will be sent to the authenticated peer by the authenticator?

  • A. Authenticate-Ack
  • B. Authenticate-Nak
  • C. Authenticate-Reject
  • D. Authenticate-Reply

Answer: B

NEW QUESTION 12
Which of the following statements are correct about TTL field in IP packet?(Choose two)
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">

  • A. The maximum value of TTL is 65535
  • B. Normally, it's impossible for a router to receive a packet whose TTL is zero.
  • C. The main purpose of TTL is to prevent IP packets from circulating endlessly in a network which canconsume a lot of bandwidth
  • D. TTL value will be decremented as a packet is passed through the network devices such as hub, LAN switchand router.

Answer: BC

NEW QUESTION 13
On VRP platform, which of the following parameters can be used together with the "ping" command to specifythe source address of an echo request message?

  • A. A
  • B. S
  • C. D
  • D. N

Answer: A

NEW QUESTION 14
<R2>debugging rip 1
Sep 13 2013 11:07:20.974.1-05:13 R2 RIP/7/DBG: 6: 13414: RIP 1: Receiving v1 response
on
GigabitEthernet0/0/0 from 10.0.12.1 with 1 RTE
Sep 13 2013 11:07:20.974.2-05:13 R2 RIP/7/DBG: 6: 13465: RIP 1: Receive response
from 10.0.12.1 on GigabitEthernet0/0/0
Sep 13 2013 11:07:20.974.3-05:13 R2 RIP/7/DBG: 6: 13476: Packet: Version 1, Cmd
response, Length 24
Sep 13 2013 11:07:20.974.4-05:13 R2 RIP/7/DBG: 6: 13527: Dest 1.0.0.0, Cost 1
Sep 13 2013 11:07:20.974.5-05:13 R2 RIP/7/DBG: 6: 2688: RIP 1: Ignoring packet. This
version is notconfigured.
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not asexpected and performs debugging. Based on the output from the debug, what is the source of the problem?

  • A. R2 has configured an ACL to block the route to network 1.0.0.0
  • B. R2 has enabled split horizon.
  • C. R1 is using authentication, however R2 is not.
  • D. R2 is operating using RIPv2, while R1 is using RIPv1.

Answer: D

NEW QUESTION 15
When configuring a router as a PPPoE client, which configuration is not necessary?

  • A. Configuration of the dialer-rule
  • B. Configuration of the dialer interface
  • C. Configuration of an IP address on the dialer interface
  • D. Configuration of a password on the dialer interface

Answer: C

NEW QUESTION 16
Which of the following regarding Frame Relay DLCI are correct?(Choose three)

  • A. DLCI is locally significant
  • B. DLCI is allocated by DTE
  • C. The range of DLCI value that can be used is from 16-1007
  • D. The same DLCI can be configured on different physical interfaces

Answer: ACD

NEW QUESTION 17
On the interface serial 1/0/1 of RTA,the command “ip address unnumbered interface loopback 0” has beenconfigured. Which following statements are correct?(Choose two).

  • A. The IP address of interface serial 1/0/1 is 10.1.1.1/24
  • B. The IP address of interface serial 1/0/1 is 10.1.1.1/32
  • C. The route entry 10.1.1.0/24 exists in RTA’s routing-table
  • D. The route entry 10.1.1.0/24 does not exist in RTA’s routing-table

Answer: BD

NEW QUESTION 18
[RTA]acl 2001
[RTA-acl-basic-2001]rule permit source 10.0.1.0 0.0.0.255
[RTA-acl-basic-2001]rule deny source 10.0.1.0 0.0.0.255
Refer to the configuration output. Which of the following statements regarding ACL 2001 is correct?

  • A. Packets from network 10.0.1.0/24 network will be denied.
  • B. Packets from network 10.0.1.0/24 network will be permitted.
  • C. Packets destined for network 10.0.1.0/24 will be denied.
  • D. Packets destined for network 10.0.1.0/24 will be permitted.

Answer: B

100% Valid and Newest Version H12-211 Questions & Answers shared by 2passeasy, Get Full Dumps HERE: https://www.2passeasy.com/dumps/H12-211/ (New 233 Q&As)