Testking offers free demo for ccda 200 310 dump exam. "Designing for Cisco Internetwork Solutions", also known as ccda 200 310 exam, is a Cisco Certification. This set of posts, Passing the Cisco 200 310 pdf exam, will help you answer those questions. The 200 310 dumps Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 200 310 desgn exams and revised by experts!
♥♥ 2017 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 200-310 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Q101. What are the three modes of unicast reverse path forwarding? (Choose three.)
Q102. Which Cisco device management feature is most suited to metering network traffic and providing data for billing network usage?
B. Cisco Discovery Protocol
Q103. Which model of ISR is utilized for the teleworker design profile? A. Cisco 1900 Series
B. Cisco 1800 Series
C. Cisco 800 Series
D. Cisco 500 Series
Q104. DRAG DROP
Q105. A client wants to deploy a video conferencing platform in a multisite WAN environment. What two design considerations need to be evaluated? (Choose two.)
A. CODECs supported by the video units
B. buffer sizes on the routers
C. POE capabilities of the switches
D. number of current calls
E. number of hops between sites
Q106. What significant advantage does EIGRP have over OSPF?
A. easy summarization
B. shorter convergence times
C. single area operation
D. low processor utilization
Q107. An organization is deciding what routing protocol to use throughout their network. What must be considered if routing is to be performed at the access layer?
A. reduced scalability of the network when introducing a large number of switch blocks into the routing table
B. centralized management of access control lists at the distribution layer
C. reliability when implementing routing over spanning-tree at the access layer
D. performance differences between core, distribution and access layer equipment
Q108. A network engineer is using the traditional switched hierarchical design. The client has asked to increase uplink utilization from the access layer to the distribution. How can the engineer attain this new requirement without adding new physical connections?
A. enable spanning-tree portfast
B. enable VSS at the distribution layer
C. increase the MTU size on the uplink interfaces
D. ensure the root bridge priority is equal on both distribution switches
Q109. Which WLC interface is dedicated for WLAN client data?
A. virtual interface B. dynamic interface
C. management interface
D. AP manager interface
E. service port interface
WLC Interface Types
A WLC has five interface types:
Management interface (static, configured at setup, mandatory) is used for in-band management, connectivity to AAA, and Layer 2 discovery and association.
Service-port interface (static, configured at setup, optional) is used for out-of-band management. It is an optional interface that is statically configured.
AP manager interface (static, configured at setup, mandatory except for 5508 WLC) is used for Layer 3 discovery and association. It has the source IP address of the AP that is statically configured.
Dynamic interface (dynamic) is analogous to VLANs and is designated for WLAN client data.
Virtual interface (static, configured at setup, mandatory) is used for leaver 3 security authentication, DHCP relay support, and mobility management.
Q110. Which technology enables WLCs to peer with each other to enable roaming support?
A. WAP profiles
B. roaming profiles
C. mobility groups