Master the 400 101 ccie CCIE Routing and Switching (v5.0) content and be ready for exam day success quickly with this Examcollection cisco 400 101 exam question. We guarantee it!We make it a reality and give you real cisco 400 101 questions in our Cisco ccie 400 101 dumps braindumps.Latest 100% VALID Cisco 400 101 vce Exam Questions Dumps at below page. You can use our Cisco 400 101 pdf braindumps and pass your exam.


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 400-101 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 400-101 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/400-101-exam-dumps.html

P.S. Downloadable 400-101 testing material are available on Google Drive, GET MORE: https://drive.google.com/open?id=1PNhgQt-GcY21rRYa-QnhQBRYmDFoQVqt


New Cisco 400-101 Exam Dumps Collection (Question 1 - Question 10)

Q1. Which feature provides local database policy options that are similar to those ofTACACS-t- and RADIUS servers?

A. authentication fallback

B. reflexive ACLs

C. AAA attributes

D. 802.1x

Answer: D


Q2. Refer to the exhibit.

The Main 1 and Branch 1 switches are connected directly over over an MPLS pseudowire, and both runn UDLD. After router B1 reloads because of a power failure, the pseudowire. However the Branch 1 switch is unable to reach the Main 1 switch. Which two actions can you take to restore connectivity and problem from recurring? (Choose two)

A. Configure a backup pseudowire between the Main 1 and Branch I Switchs.

B. Issue the shutdown and no shutdown commands on the Branch 1 switch uplink to the B1 router only.

C. Configure a backup GRE tunnel between the Main I and Branch 1 switches.

D. Issue the shutdown and no shutdown commands on both the Branch 1 switch uplink to the B1 router and the Main 1 switch's uplink to the M1 router

E. Enable errdisable recovery on both the Main I and Branch I switches.

F. Enable UDLD recovery on both the Main I and Branch I switches.

Answer: B,E


Q3. Refer to the exhibit.

Which two statements about this configuration are true? (Choose two)

A. It creates summary routes and injects them into EIGRP

B. It prevent 172.16.0.0/16 from being distributed into EIGRP

C. It allows a default route to be distributed into EIGRP

D. It prevent a default route to being distributed into EIGRP

E. It allows 172.16.0.0/16 and larger students to be distributed into EIGRP

F. It allow 172.16.0.0/16 to be distributed into EIGRP

Answer: C,F


Q4. Refer to the exhibit.

Which statement is true?

A. The Cisco PfR state is UP; however, the external interface Et0/1 of border router

10.1.1.1 has exceeded the maximum available bandwidth threshold.

B. The Cisco PfR state is UP; however, an issue is preventing the border router from establishing a TCP session to the master controller.

C. The Cisco PfR state is UP and is able to monitor traffic flows; however, MD5 authentication has not been successful between the master controller and the border routers.

D. The Cisco PfR State is UP; however, the receive capacity was not configured for inbound traffic.

E. The Cisco PfR state is UP, and the link utilization out-of-policy threshold is set to 90 percent for traffic exiting the external links.

Answer: E

Explanation:

All three interfaces show as UP, and the capacity is set to 500 kbps, with the max threshold set to 450 kbps (90% of 500kbps).


Q5. Which statement about the RPF interface in a BIDIR-PIM network is true?

A. In a BIDIR-PIM network the RPF interface can be the interface that is used reach the PIM rendezvous or the interface that is used to reach the source.

B. In a BIDIR-PIM network the RPF interface is always the interface that is used to reach the source.

C. There is no RPF interface concept in BIDIR-PIM networks

D. In a BIDIR network the RPF interface is always the interface that is used to reach the PIM rendezvous point.

Answer: D


Q6. Exhibit:

Refer to the exhibit. What is the DSCP value that egresses SW2 toward R2?

A. 0

B. 2

C. 8

D. 10

E. 16

Answer: A


Q7. Which two statements about lANA-reserved addresses are true?(Choose two.)

A. The prefix FF9::/32 is reserved for source-specific multicast on IPv6.

B The address range 239 0.0.0/8 is reserved for source-specific multicast on IPv4.

B. The address range 232.0.0.0/8 is reserved for source-specific multicast on IPv4.

C. The prefix FF3x::/32 is reserved for source-specific multicast on IPv6.

E The address range 225.0.0.0/8 is reserved for source-specific multicast on IPv4.

D. The prefix FF00::/32 is reserved for source-specific multicast on IPv6.

Answer: C,D


Q8. An IP SLA fails to generate statistics. How can you fix the problem?

A. Add the verify-data command to the router configuration

B. Reload the router configuration.

C. Remove the ip sla schedule statement from the router configuration and re-enter it.

D. Add the debug ip sla trace command to the router configuration.

E. Add the debug ip sla error command to the router configuration.

Answer: A


Q9. Which IPv6 tunneling type establishes a permanent link between IPv6 domains over IPv4?

A. 6to4 tunneling

B. ISATAP tunneling

C. IPv4-compatible tunneling

D. manual tunneling

Answer: D


Q10. Which two statements about SSM are true? (Choose two)

A. It is designed to support many-to-many applications within a PIM domain.

B. It requires IGMPv3 for source filtering.

C. It uses (*, G) multicast routing entries to make forwarding decisions.

D. It can work in conjunction with the ISM service.

E. Its application and protocols use address 233.0.0.0 - 233.255.255.255.

Answer: B,D


Recommend!! Get the Downloadable 400-101 dumps in VCE and PDF From Allfreedumps, Welcome to download: https://www.allfreedumps.com/400-101-dumps.html (New 911 Q&As Version)