Tested of 300-365 exam materials and resource for Cisco certification for IT engineers, Real Success Guaranteed with Updated 300-365 pdf dumps vce Materials. 100% PASS Deploying Cisco Wireless Enterprise Networks exam Today!
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-365 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Q11. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this?
A. Cisco MSE as NetFlow exporter
B. Prime Infrastructure 1.0 or later
C. Cisco NAC as NetFlow exporter
D. Cisco ISE as NetFlow exporter
Q12. A customer has "quiet" wireless clients that use static IP addresses. Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.)
A. Disable DHCP address assignment required.
B. Enable passive client.
C. Disable allow AAA override.
D. Enable static IP tunneling.
E. Disable DHCP server override.
Q13. A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented. How should the engineer perform the password recovery?
A. Use a console cable.
B. Contact Cisco TAC and arrange an RMA of the MSE.
C. Boot the MSE using the software installation DVD.
D. The Password can be reset using Prime Infrastructure.
There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are.
What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.)
A. Change the AP in the Employees-East-Wing AP Group.
B. Change the IP Address in the east-wing interface.
C. Change the VLAN Identifier in the east-wing interface.
D. Enable Dynamic AP Management in the east-wing interface.
E. Change the Port Number to 2 in the east-wing interface.
F. Add the Primary Controller and IP address to the 3700-East-Wing AP.
G. Change the SSID in the Employees-East-Wing AP Group.
H. Change the Interface/Interface Group In the Employees-East-Wing AP Group.
Q15. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause of the drop in video?
A. Clients are roaming at lower data rates and are not maintaining 36Mbps connectivity.
B. Clients are not roaming due to coverage. This is causing the multicast data to drop due to the client re-associating often.
C. Clients are connected at 18Mbps; however, other clients are connecting at 12Mbps and are causing the multicast video to degrade.
D. Clients are maintaining a 12Mbps rate and cannot receive the stream at 18Mbps.
Q16. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal?
A. mobility groups
B. flex-connect groups
C. interface groups
D. AP groups
Q17. CORRECT TEXT
One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504A.
Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port.
Not all menus, tabs and features are supported.
Q18. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?
Q19. A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple interfaces defined on the WLC and mapped to a single interface group. Which configuration meets this need?
A. 264 interfaces of/25 sized networks
B. 132 interfaces of/24 sized networks
C. 66 interfaces of/23 sized networks
D. 33 interfaces of /22 sized networks
Q20. A customer has limited staff to manage a wireless network. The customer wants a solution that requires minimum hardware. Which type of architecture do you propose?