Abreast Of The Times 300-170 Bundle 2021

NEW QUESTION 1
Drag and drop each Cisco ACI model component on the left to the correct description on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 2
The behavior of which packet type can be controlled by selecting unicast mode or flood mode in a bridge domain?

• A. ARP
• B. unknown unicast
• C. LLDP
• D. CDP

Answer: B

NEW QUESTION 3
Which two method does a Cisco APIC supports to connect to the management IP address of a service appliance? (Choose two.)

• A. out-of-band connectivity to devices in device clusters by using the management VLAN D in band connectivity to devices in device clusters by using the VRF of the tenant
• B. out-of-band connectivity to devices m device clusters by using the VRF of the tenant
• C. out-of-band connectivity to devices m device clusters by using the management VRF of the tenant
• D. in band connectivity to devices m device clusters by using the management VRF of the tenant

Answer: AB

NEW QUESTION 4
Which management interface is selected by the Cisco APIC by default if an in band management interface and an out of-band management interface exist?

• A. In-band is preferred
• B. The first configured interface is selected
• C. The interface that has the highest priority is selected
• D. Out-of band is preferred

Answer: D

NEW QUESTION 5
Refer to the exhibit.

Which port is used for communication between the server and the Cisco Integrated Management Controller?

• A. ports on the adapter card
• B. management Ethernet port
• C. LAN on the motherboard port
• D. fabric uplink port

Answer: C

NEW QUESTION 6
Which feature of a Cisco Nexus 1000V Servers Switch allows you to deploy traffic steering for a virtual infrastructure?

• A. SOT
• B. PVLAN
• C. ACL
• D. vPath

Answer: D

NEW QUESTION 7
Which option must be configured to allow SNMP communications and traffic?

• A. an out of-band bridge domain
• B. an out-of-band contract
• C. an out-of-band policy
• D. an out-of-band management interface

Answer: D

NEW QUESTION 8
Which configuration is needed to extend the EPG out of the Cisco ACI fabric?

• A. Create external bridged networks
• B. Statically assign a port to EPGC Apply a policy between the internal and the external EPG
• C. Extend the tenant subnet of the bridge domain out of the fabric

Answer: B

NEW QUESTION 9
Which two Cisco UCS components require drivers? (Choose two )

• A. FNIC
• B. BIOS
• C. CIMC
• D. board controller
• E. ENIC

Answer: AE

NEW QUESTION 10
Which statement accurately describes Cisco ACI flooding mode for unknown unicast traffic?

• A. By default unknown unicast traffic floods the bridge domain
• B. By default, all unknown unicast traffic is dropped
• C. A hardware proxy must be used for flooding mode
• D. By default, an unknown unicast traffic is sent to the spine proxy

Answer: D

NEW QUESTION 11
You have a Cisco Nexus 1000V Series Switch. When must you use the system VLAN?

• A. to use VMware vMotion
• B. to perform an ESXi iSCSI boot
• C. to perform a VM iSCSI boot
• D. to perform an ESXi NFS boot

Answer: A

NEW QUESTION 12
Drag and drop the actions on the left to the corresponding scripting tools on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 13
Refer to Exhibit.

In which bridge domain does enabling hardware proxy have the greatest benefit?

• A. BD1
• B. BD2
• C. BD3
• D. BD4

Answer: D

NEW QUESTION 14
You have a Cisco Nexus device that is configured to use RADIUS serve. What occur when local RBAC user account roles and RADIUS roles exist simultaneously?

• A. Only rules that are in the local roles and the RADIUS roles are applied
• B. Only rules from the local roles are applied.
• C. Only rules from the RADIUS roles are applied.
• D. The rules from the local roles and the RADIUS roles are merged.

Answer: B

NEW QUESTION 15
You have a new Cisco Nexus 7000 Series Switch that has only the default VDC configured .Which option describes the default behavior of the physical interfaces on the switch?

• A. The physical ports are divided into eight groups and the first group is assigned to the default VDC
• B. AJI of the physical ports on the switch are assigned to the default VDC
• C. None of the physical ports on the switch are assigned
• D. The physical ports are divided into six groups and the first group is assigned to the default VDC

Answer: C

NEW QUESTION 16
Which Cisco UCS backup type results in an XML file that includes all system and logical configuration settings?

• A. system configuration
• B. all configuration
• C. full state
• D. logical configuration

Answer: B

NEW QUESTION 17
Which protocol is used as the link-state routing protocol for a DFA fabric?

• A. VXLAN
• B. EIGRP
• C. Fabric Path IS-IS
• D. OSPF

Answer: C

NEW QUESTION 18
You are performing VMM integration between ACI and VMware with vDS. You place a Cisco UCS Fabric Interconnect between the leaf and the ESXi hosts running on UCSB series Which is a valid configuration if using VMM integration with "On Demand" resolution?

• A. In the interface policy group, disable LLDP, enable Cisco Discovery Protocol, and then select MAC pinning on the Fabric Interconnects
• B. In the interface policy, enable LLD
• C. Cisco Discovery Protocol, and LACP
• D. In the interface pokey group, disable LLDP, disable Cisco Discovery Protocol, and then select active in the LACP pokey
• E. Configure LLD
• F. Cisco Discovery Protocol, and LACP policies under global policies to match the interface policies

Answer: A

NEW QUESTION 19
When configuring port profiles on a Cisco Nexus 5000 Series switch, which two statements are true? (Choose two.)

• A. If a conflict occurs when a range of interfaces inherits a second port profile, the commands of the initial port profile override the commands of the second port profile.
• B. If a conflict occurs, commands that you enter the interface mod take precedence over profile commands.
• C. When an interface has a port profile applied to it, no other conflicting configuration can be applied to that interface.
• D. If a conflict occurs when a range of interface inherits a second port profile, the commands of the second ort profile override the commands of the initial port profile.
• E. If a conflict occurs, port profile takes precedence over commands that you enter under the interface mode.

Answer: BD

NEW QUESTION 20
A host connected to a leaf switch sends an ARP request By default, what does the ingress switch do with the ARP requests?

• A. Suppress the ARP
• B. Send the ARP by using unicast.
• C. Send the ARP by using a broadcast
• D. Send the ARP by using multicast

Answer: C

NEW QUESTION 21
Which Cisco APlC health score will be affected if an EPG does not have a Bridge Domain associated with it ?

• A. spine health
• B. leaf health
• C. tenant health
• D. pod health

Answer: C

Explanation:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI
/guide/b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_01010.pdf

NEW QUESTION 22
What is the retention period for remotely attached endpoint?

• A. 3 minutes
• B. 15 minutes
• C. 5 minutes
• D. 10 minutes

Answer: A

Explanation:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/aci-fundamentals/b_A
CI-Fundamentals/b_ACI-Fundamentals_chapter_010010.html

NEW QUESTION 23
Refer to the exhibit.

What is created by the configuration?

• A. an L3Out
• B. an L3OUT-1 bridge domain
• C. three subnets within a BD
• D. a CTX1 tenant

Answer: A

NEW QUESTION 24
You are deploying L4-L7 services within Cisco Application Centric Infrastructure You need to modify an existing service graph. Where do you configure this?

• A. under the provider EPG
• B. on a connector within a service graph
• C. on a function profile within a service graph
• D. on a terminal node within a service graph

Answer: A

Explanation:
http://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c11-734298.html

NEW QUESTION 25
......