Accurate of ccnp route 300 101 dumps pdf simulations materials and preparation labs for Cisco certification for candidates, Real Success Guaranteed with Updated examcollection 300 101 pdf dumps vce Materials. 100% PASS ROUTE Implementing Cisco IP Routing exam Today!


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 300-101 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-101 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/300-101-exam-dumps.html

P.S. Accurate 300-101 preparation labs are available on Google Drive, GET MORE: https://drive.google.com/open?id=1oF6hAYEiseB3LPIXYA2sgTXv0r2MX46d


New Cisco 300-101 Exam Dumps Collection (Question 14 - Question 23)

Question No: 14

What does the following access list, which is applied on the external interface FastEthernet 1/0 of the perimeter router, accomplish?

router(config)#access-list 101 deny ip 10.0.0.0 0.255.255.255 any log

router (config)#access-list 101 deny ip 192.168.0.0 0.0.255.255 any log

router (config)#access-list 101 deny ip 172.16.0.0 0.15.255.255 any log router (config)#access-list 101 permit ip any any

router (config)#interface fastEthernet 1/0 router (config-if)#ip access-group 101 in

A. It prevents incoming traffic from IP address ranges 10.0.0.0-10.0.0.255, 172.16.0.0- 172.31.255.255, 192.168.0.0-192.168.255.255 and logs any intrusion attempts.

B. It prevents the internal network from being used in spoofed denial of service attacks and logs any exit to the Internet.

C. It filters incoming traffic from private addresses in order to prevent spoofing and logs any intrusion attempts.

D. It prevents private internal addresses to be accessed directly from outside.

Answer: C


Question No: 15

A network engineer configures two connected routers to run OSPF in Area 0; however, the routers fail to establish adjacency. Which option is one of the caused for this issue?

A. Area numbers match.

B. OSPF process numbers do not match on both neighbor routers.

C. The Same MTU sizes are configured on both sides.

D. The Same OSPF router IDs are configured on both routers.

Answer: B


Question No: 16

Which Cisco Express Forwarding table or tables hold forwarding information?

A. FIB table only

B. adjacency tables only

C. FIB and adjacency tables only

D. FIB,RIB, and adjacency tables

Answer: B

Explanation: Cisco Express Forwarding uses adjacency tables to prepend Layer 2 addressing information to packets.

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipswitch_cef/configuration/15-mt/isw-cef-15-mt-book/isw-cef-overview.html


Question No: 17

Refer to exhibit.

A user calls from another branch office with a request to establish a simple VPN tunel to test a new routeru2021s tunneling capability Based on the configuration in the exhibit, which type of tunnel was configured?

A. PPTP

B. IPsec site-to-site

C. 6to4

D. EZVPN

Answer: B


Question No: 18

Refer to the exhibit.

A network administrator checks this adjacency table on a router. What is a possible cause for the incomplete marking?

A. incomplete ARP information

B. incorrect ACL

C. dynamic routing protocol failure

D. serial link congestion

Answer: A


Question No: 19

Which of the below mentioned conditions form a neighbor relationship in EIGRP? (Choose three)

A. Hello or ACK received

B. AS number match

C. Hello timer match

D. Identical metric (k values)

E. Dead Timer Match

Answer: A,B,D


Question No: 20

If you convert a WAN connection with OSPF from T1 to a Frame Relay circuit, which two actions must you take to enable the connection? (Choose two)

A. Change the OSPF network type to nonbroadcast.

B. Manually configure neighbors in the OSPF process.

C. Manually configure the hello and dead timers.

D. Change the OSPF network type to broadcast.

E. Change the OSPF network type to multipoint nonbroadcast.

Answer: A,B


Question No: 21

An engineer has configured a router to use EUI-64, and was asked to document the IPv6 address of the router. The router has the following interface parameters:

mac address C601.420F.0007 subnet 2001:DB8:0:1::/64

Which IPv6 addresses should the engineer add to the documentation?

A. 2001:DB8:0:1:C601:42FF:FE0F:7

B. 2001:DB8:0:1:FFFF:C601:420F:7

C. 2001:DB8:0:1:FE80:C601:420F:7

D. 2001:DB8:0:1:C601:42FE:800F:7

Answer: A


Question No: 22

Which two statements about uRPF are true? (Choose two)

A. The Keyword any can be used with both strict mode and loose mode.

B. Strict mode may drop legitimate traffic.

C. It is enabled globally.

D. Strict mode is most appropriate for networks with asymmetric routing.

E. Loose mode may drop traffic when asymmetric routing occurs on the network

F. It is enabled on a per interface basis.

Answer: B,F


Question No: 23

Which two actions must you perform to enable and use window scaling on a router? (Choose two.)

A. Execute the command ip tcp window-size 65536.

B. Set window scaling to be used on the remote host.

C. Execute the command ip tcp queuemax.

D. Set TCP options to "enabled" on the remote host.

E. Execute the command ip tcp adjust-mss.

Answer: A,B


Recommend!! Get the Accurate 300-101 dumps in VCE and PDF From Allfreedumps, Welcome to download: https://www.allfreedumps.com/300-101-dumps.html (New 487 Q&As Version)