Download of ccnp route 300 101 dumps pdf test preparation materials and cram for Cisco certification for candidates, Real Success Guaranteed with Updated ccnp route 300 101 pdf pdf dumps vce Materials. 100% PASS ROUTE Implementing Cisco IP Routing exam Today!

♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 300-101 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-101 Exam Dumps (PDF & VCE):
Available on:

P.S. Download 300-101 cram are available on Google Drive, GET MORE:

New Cisco 300-101 Exam Dumps Collection (Question 6 - Question 15)

Question No: 6

Refer to the exhibit.

Which interoperability technique implemented on the router would allow Host-1 to communicate with Host-2?

A. Dual Stack


C. 6to4 tunnel

D. GRE tunnel

E. ISATAP tunnel

Answer: B

Question No: 7

Refer to the exhibit. Based on the output from the show command on RT1 which statement is true?

A. OSPFv3 uses global IPv6 addresses to establish neighbor adjacencies.

B. RT1 has a subnet mask of 64 bits.

C. RT1 has FastEthernet0/0 set as a DR for network type broadcast.

D. OSPFv3 uses Link-local addresses to establish neighbor adjacencies.

E. RT1 does not have a global IPv6 address set on FastEthernet0/0.

F. OSPFv3 uses IPv4 addresses to establish neighbor adjacencies.

Answer: D


OSPFv3 is an updated version of OSPF designed to accommodate IPv6 natively. OSPFv3 uses the multicast address FF02::5 and FF02::6, but like EIGRP it uses its link-local address as the source address in advertisements.

Question No: 8

Your Company trainee asks you, in the context of IPv6 and OSPF, what best describes a type 9 LSA? What should you tell her?

A. Link LSA

B. Interarea prefix LSA for ABRs

C. Router LSA

D. Switch LSA

E. Intra-area prefix LSA

F. None of the above

Answer: E

Question No: 9

A network engineer has set up VRF-Lite on two routers where all the interfaces are in the same VRF. At a later time, a new loopback is added to Router 1, but it cannot ping any of the existing interfaces. Which two configurations enable the local or remote router to ping the loopback from any existing interface? (Choose two.)

A. adding a static route for the VRF that points to the global route table

B. adding the loopback to the VRF

C. adding dynamic routing between the two routers and advertising the loopback

D. adding the IP address of the loopback to the export route targets for the VRF

E. adding a static route for the VRF that points to the loopback interface

F. adding all interfaces to the global and VRF routing tables

Answer: A,B

Question No: 10

Refer to the exhibit.

Which option prevents routing updates from being sent to the access layer switches?

A. DWS1(config-router)# passive-interface default DWS2(config-router)# passive-interface default

B. ALS1(config-router)# passive-interface default ALS2(config-router)# passive-interface default

C. DWS1(config-router)# passive-interface gi1/1 DWS1(config-router)# passive-interface gi1/2 DWS2(config-router)# passive-interface gi1/1 DWS2(config-router)# passive-interface gi1/2

D. ALS1(config-router)# passive-interface gi0/1 ALS1(config-router)# passive-interface gi0/2 ALS2(config-router)# passive-interface gi0/1 ALS2(config-router)# passive-interface gi0/2

Answer: C

Question No: 11

Which two commands must you configure on a DMVPN hub to enable phase 3? (Choose two)

A. ip nhrp interest

B. ip nhrp redirect

C. ip nhrp shortcut

D. ip network-id

E. ip nhrp map

F. ip redirects

Answer: D,E

Question No: 12

Refer to the exhibit. The command is executed while configuring a point-to-multipoint Frame Relay interface. Which type of IPv6 address is portrayed in the exhibit?

A. link-local

B. site-local

C. global

D. multicast

Answer: A

Question No: 13

What are three IPv6 transition mechanisms? (Choose three)

A. 6to4 tunneling

B. VPN tunneling

C. GRE tunneling

D. ISATAP tunneling

E. PPP tunneling

F. Teredo tunneling

Answer: A,D,F


Below is a summary of IPv6 transition technologies:

6 to 4 tunneling: This mechanism allows IPv6 sites to communicate with each other over the IPv4 network without explicit tunnel setup. The main advantage of this technology is that it requires no end-node reconfiguration and minimal router configuration but it is not intended as a permanent solution.

ISATAP tunneling (Intra-Site Automatic Tunnel Addressing Protocol): is a mechanism for transmitting IPv6 packets over IPv4 network. The word u201cautomaticu201d means that once an ISATAP server/router has been set up, only the clients must be configured to connect to it. Teredo tunneling: This mechanism tunnels IPv6 datagrams within IPv4 UDP datagrams, allowing private IPv4 address and IPv4 NAT traversal to be used.

In fact, GRE tunneling is also a IPv6 transition mechanism but is not mentioned in BSCI so we shouldnu2021t choose it (there are 4 types of IPv6 transition mechanisms mentioned in BSCI; they are manual, 6-to-4, Teredo and ISATAP).

Question No: 14

A network engineer has configured a tracking object to monitor the reachability of IP SLA 1. In order to update the next hop for the interesting traffic, which feature must be used in conjunction with the newly created tracking object to manipulate the traffic flow as required?







Answer: B

Question No: 15

In IPv6, the interfaces running OSPF can be configured with multiple address prefixes.

Which statement is true about the IPv6 addresses that can be included into the OSPF process?

A. Specific addresses cannot be selected for importation into the OSPF process.

B. Specific addresses can be selected using an ACL.

C. Specific addresses can be selected using a route map.

D. Specific addresses can be selected using a prefix list.

Answer: A

Explanation: BGP.pdf (slide 20, 3rd bullet)

Recommend!! Get the Download 300-101 dumps in VCE and PDF From Thedumpscentre, Welcome to download: (New 487 Q&As Version)