Examcollection 200 355 vce Questions are updated and all ccna wireless 200 355 official cert guide pdf free download answers are verified by experts. Once you have completely prepared with our ccna wireless 200 355 pdf exam prep kits you will be ready for the real 200 355 dumps exam without a problem. We have Refresh Cisco 200 355 pdf dumps study guide. PASSED cisco 200 355 First attempt! Here What I Did.


♥♥ 2017 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 200-355 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-355 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/200-355-exam-dumps.html

Q131. Which Cisco program for WLAN client vendors helps to ensure that their devices are interoperable with Cisco WLAN infrastructure? 

A. CCX 

B. CCMP 

C. ASDM 

D. WLSE 

Answer: A 


Q132. An engineer wants to setup WPA2 Enterprise using EAP-TLS and a remote RADIUS server. What device(s) would the engineer specify the EAP type on? 

A. the supplicant and authentication server 

B. the supplicant and authenticator 

C. the authenticator and authentication server 

D. the supplicant only 

E. the authentication server only 

Answer: A 


Q133. What is the maximum number of access points supported on Cisco WCS with an enterprise license? 

A. 5,000 

B. 10,000 

C. 50,000 

D. 100,000 

Answer: C 


Q134. Which three AP modes of operation allow for the wIPS sub mode? (Choose three.) 

A. local mode 

B. bridge mode 

C. monitor mode 

D. H-REAP mode 

E. rogue detector mode 

F. SE-Connect mode 

G. sniffer mode 

Answer: A,C,D 


Q135. In a network with a deployed Cisco WLC, which two entities must be configured with the shared secret key for 802.1X authentication? (Choose two.) 

A. WLC 

B. RADIUS server 

C. AP 

D. supplicant 

E. wireless client 

Answer: A,B 


Q136. An 802.11g network is experiencing intermittent signal degradation and Spectrum Analyzer is being used to try and locate the problem. What two interferers would likely be identified? (Choose two.) 

A. multiple cell phones 

B. microwave oven 

C. FM Radio 

D. cordless phone 

E. document scanner 

Answer: B,D 


Q137. What is the difference between the IEEE, the WiFi Alliance, and the FCC, ETSI, and TELEC? 

A. The IEEE and FCC are responsible for the standards that apply to wireless networks. The WiFi Alliance, ETSI, and TELEC are the governmental agencies that regulate compliance with local standards. 

B. The IEEE is responsible for Layer 1 and Layer 2 protocols. The WiFi Alliance is responsible for interoperability testing. The FCC, ETSI, and TELEC are responsible for radio frequency and transmission power-level regulations and standards in the U.S., Europe, and Japan. 

C. The IEEE is responsible for Layer 1 and Layer 2 protocols. The FCC, ETSI, and TELEC are responsible for interoperability testing and compliance. The WiFi Alliance is responsible for radio frequency and transmission power-level regulations and standards on a global basis. 

D. The IEEE and FCC are responsible for the Layer 3 protocol support and frequency and power-level regulations in the United States. ETSI and TELEC are responsible for frequency and power-level regulations in Europe and Japan. The WiFi Alliance is responsible to interoperability testing. 

Answer: B 


Q138. A network engineer is troubleshooting a LAP that is unable to join the controller and receives the message below: 

LWAPP_CLIENT_ERROR_DEBUG. No more AP manager IP addresses remain What does the log indicate? 

A. Two or more LAPs have the same IP address. 

B. An AP manager has the same IP address as another AP manager. 

C. A LAP has the same IP address as the AP manager. 

D. Two or more controllers have the same IP address. 

Answer: C 


Q139. The existing Cisco Unified Wireless Controller is running version 7.0 code for both the controllers and the Cisco WCS. A controller has been configured with an appropriate rogue rule condition to report discovered APs to the Cisco WCS. 

Which default alarm level is used to display all rogue APs in the Alarm Summary? 

A. Critical 

B. Flash 

C. Urgent 

D. Major 

E. Minor 

Answer: E 


Q140. RAG DROP 

Answer: