There is the interactive space in Exambible. You can chat with other examinees. Learn via each other as well as make progress together. Your candidates who have approved the Cisco 200-355 exam will pass on their own wisdom to you. Help to make full using their Cisco examination notes. Theyre an invaluable asset to your Cisco Cisco exam preparation. You will find probably the most advanced, appropriate and guaranteed Cisco 200-355 exam questions as well as answers. You will end up being ready for the Cisco 200-355 exam questions on the examination day. Discover more 200-355 expertise and lay any solid foundation for advancements inside Cisco Cisco 200-355 career.

2017 Mar 200-355 braindumps

Q51. What is the IEEE name for a group of access points that are connected by using the Ethernet? 

A. ESS 

B. BSS 

C. IBSS 

D. ISS 

Answer:


Q52. You are setting up a laptop to connect to the wireless network of your organization. The protocols that are used for the corporate network are WPA2 Enterprise, PEAP, and AES. Which three parameters do you need to configure in the Windows 7 wireless network properties for this connection? (Choose three.) 

A. VLAN 

B. encryption type 

C. authentication method 

D. VRF 

E. security type 

F. IP address 

Answer: B,C,E 


Q53. An installation uses a 21dBi parabolic dish. It is connected to the 802.11n radio via low loss antenna coax rated at 4dB loss/100 feet. After testing, it has been determined that 2mW of power will be lost in the cable. An EIRP producing 200mW is desired. What should the transmit power be set to? 

A. 8mW 

B. 3dBm 

C. 3.16mW 

D. 5mW 

Answer:


Q54. Which two statements about the results of the Cisco WCS version 7.0 client troubleshooting tool are true? (Choose two.) 

A. Results of Layers 1 - 3 are provided. 

B. Results of only Layers 2 and 3 are provided. 

C. Results of Layers 4 - 7 are provided. 

D. The tabulated results vary depending on the client type. 

E. Results are provided in a fixed four-part tabulation. 

F. Results are provided in a fixed six-part tabulation. 

Answer: A,D 


Q55. What tab contains access point configuration in the WCS? 

A. Controller > Access Points 

B. Configure > Access Points 

C. General > Configure > Access Points 

D. System > Configure > Access Points 

Answer:


Avant-garde 200-355 download:

Q56. You are configuring an IP address on an autonomous access point. Which interface do you use to configure the IP address? 

A. BVI1 

B. FastEthernet 0 

C. Dot11Radio0 

D. VLAN 1 

Answer:


Q57. During an upgrade, the wireless infrastructure has seen a few access points join and then drop off the network. After further investigation, it appears the access points may have an IOS code version that is causing issues. Where in the controller is this information found? 

A. GUI > Wireless > Access Point > General 

B. CLI > show ap image all 

C. GUI > Monitor > Software Version 

D. CLI > show sysinfo 

Answer:


Q58. Refer to the exhibit. 

Which option must be chosen if only the WPA is needed? 

A. WPA+WPA2 

B. Static-WEP + 802.1X 

C. 802.1X 

D. CKIP 

Answer:


Q59. Which two statements about the Cisco WLC and AP code upgrade when 7.0 is running are true? (Choose two.) 

A. The AP can download and run new code only after a Cisco WLC reboot causes the AP discovery and join. 

B. The AP can download new code before the Cisco WLC reboot, but only if the AP is configured the CLI via SSH. 

C. The AP can download new code before Cisco WLC reboot if it is configuring the Cisco WLC directly using the GUI via HTTP or HTTPS. 

D. The Cisco WLC defaults to booting newer code, but it can boot older backup code only from the CLI configuration. 

E. The Cisco WLC can boot either primary or backup code configured from the GUI. 

F. The Cisco WLC can download only a single code at a time for reboot. 

Answer: C,E 


Q60. Which statement describes spread spectrum technology in wireless communications? 

A. Signal is spread across optical pulses. 

B. Signal is spread across variations of amplitudes. 

C. Signal is spread across one frequency. 

D. Signal is spread across a whole band of frequencies. 

Answer: