Master the ccda 200 310 official cert guide pdf Designing for Cisco Internetwork Solutions content and be ready for exam day success quickly with this Examcollection ccda 200 310 dump exam. We guarantee it!We make it a reality and give you real ccda 200 310 official cert guide questions in our Cisco 200 310 desgn pdf braindumps.Latest 100% VALID Cisco ccda 200 310 pdf Exam Questions Dumps at below page. You can use our Cisco ccda 200 310 braindumps and pass your exam.


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 200-310 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-310 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/200-310-exam-dumps.html

Q11. What routing protocol requires full mesh between internal peers in an enterprise network? 

A. OSPF 

B. EIGRP 

C. BGP 

D. ISIS 

E. RIP 

Answer:


Q12. Which of the following three options represents the components of the Teleworker Solution? (Choose three.) 

A. Cisco Unified IP Phone 

B. Cisco 880 Series Router 

C. Aironet Office Extend Access Point 

D. Catalyst 3560 Series Switch 

E. Cisco 2900 Series Router 

F. MPLS Layer 3 VPN 

G. Leased lines 

Answer: A,B,E 

Explanation: 

A Cisco ASR is used to terminate Teleworker solutions, not a 2900 series router. Hybrid teleworker uses Aironet, Advanced teleworker uses 880, both use IP phones. google: "at_a_glance_c45-652500.pdf" for details 

The Cisco Virtual Office Solution for the Enterprise Teleworker is implemented using the Cisco 800 series ISRs. Each ISR has integrated switch ports that then connect to the user’s broadband connection. The solution uses a permanent always-on IPsec VPN tunnel back to the corporate network. This architecture provides for centralized IT security management, corporate-pushed security policies, and integrated identity services. In addition, this solution supports the enterprise teleworker needs through advanced applications such as voice and video. For example, the enterprise teleworker can take advantage of toll bypass, voicemail, and advanced IP phone features not available in the PSTN. 

Enterprise Teleworker Module 

The enterprise teleworker module consists of a small office or a mobile user who needs to access services of the enterprise campus. As shown in Figure 2-14, mobile users connect from their homes, hotels, or other locations using dialup or Internet access lines. VPN clients are used to allow mobile users to securely access enterprise applications. The Cisco Virtual Office solution provides a solution for teleworkers that is centrally managed using small integrated service routers (ISR) in the VPN solution. IP phone capabilities are also provided in the Cisco Virtual Office solution, providing corporate voice services for mobile users. 


Q13. Which two features are supported by single wireless controller deployments? (Choose two.) 

A. automatic detection and configuration of LWAPPs 

B. LWAPP support across multiple floors and buildings 

C. automatic detection and configuration of RF parameters 

D. Layer 2 and Layer 3 roaming 

E. controller redundancy 

F. mobility groups 

Answer: A,B 


Q14. What is the benefit of VLSM? 

A. reduces configuration complexity by using the same subnet mask length 

B. reduces the routing table size by using automatic route summarization 

C. reduces the routing table size by using manual route summarization 

D. allows the subnet mask and classful routing updates to be advertised 

E. secures the hosts on a subnet by using RFC 1918 addresses 

Answer:


Q15. By default, how does EIGRP's metric differ from OSPF? 

A. hops 

B. cost 

C. bandwidth 

D. delay 

Answer:


Q16. What is the primary advantage of implementing a wireless LAN controller in a wireless LAN design? 

A. roaming between APs 

B. RADIUS user authentication 

C. radio resource management 

D. accelerated data transfer 

Answer:


Q17. Which factor would be most influential in choosing multimode fiber optic connections over UTP? 

A. signal attenuation 

B. required bandwidth 

C. required distance 

D. electromagnetic interference 

E. cost 

Answer:


Q18. To provide Layer 2 connectivity between the primary and remote data centers, given that the two data centers are using Layer 3 routed DCIs, which NX-OS technology can be used to facilitate this requirement? 

A. VRF 

B. OTV 

C. MPLS 

D. SPT 

E. VPC 

Answer:


Q19. Which IPv6 feature enables routing to distribute connection requests to the nearest content server? 

A. Link-local 

B. Site-local 

C. Anycast 

D. Multicast 

E. Global aggregatable 

Answer:

Explanation: Any cast is a network addressing and routing methodology in which data grams from a single sender are routed to the topologically nearest node in a group of potential receivers all identified by the same destination address. Link: http://en.wikipedia.org/wiki/Anycast 


Q20. Which two design approaches provide management of enterprise network devices? (Choose two.) 

A. in-band 

B. out-of-line 

C. out-of-band 

D. in-line 

Answer: A,C