Passleader NSE7_SDW-6.4 Questions are updated and all NSE7_SDW-6.4 answers are verified by experts. Once you have completely prepared with our NSE7_SDW-6.4 exam prep kits you will be ready for the real NSE7_SDW-6.4 exam without a problem. We have Most up-to-date Fortinet NSE7_SDW-6.4 dumps study guide. PASSED NSE7_SDW-6.4 First attempt! Here What I Did.
Check NSE7_SDW-6.4 free dumps before getting the full version:
NEW QUESTION 1
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. FortiGate has terminated the session after a change on policy ID 1.
- C. Changes have been made on firewall policy ID 1 on FortiGate.
- D. Firewall policy ID 1 has source NAT disabled.
Answer: C
NEW QUESTION 2
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Specify a unique peer ID for each dial-up VPN interface.
- B. Use different proposals are used between the interfaces.
- C. Configure the IKE mode to be aggressive mode.
- D. Use unique Diffie Hellman groups on each VPN interface.
Answer: BD
NEW QUESTION 3
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set priority 10.
- B. Set cost 15.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set source 100.64.1.1.
Answer: D
NEW QUESTION 4
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- B. XAuth is enabled as an additional level of authentication, which requires a username and password.
- C. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
Answer: BC
NEW QUESTION 5
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify outgoing interface routing cost.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify incoming interfaces in SD-WAN rules.
Answer: AB
NEW QUESTION 6
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- B. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- C. The zero-touch provisioning process has completed internally, behind FortiGate.
- D. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- E. A factory reset performed on FortiGate.
Answer: AC
NEW QUESTION 7
Refer to exhibits. Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The dead member interface stays unavailable until an administrator manually brings the interface back.
- B. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- C. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- D. Check interval is the time to wait before a packet sent by a member interface considered as lost.
Answer: B
NEW QUESTION 8
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
Answer: BD
NEW QUESTION 9
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link intf-sla-log
Answer: C
NEW QUESTION 10
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. VPN topologies are formed using only BGP dynamic routing with SD-WAN
Answer: D
NEW QUESTION 11
Which statement is correct about the SD-WAN and ADVPN?
- A. ADVPN interface can be a member of SD-WAN interface.
- B. Dynamic VPN is not supported as an SD-Wan interface.
- C. Spoke support dynamic VPN as a static interface.
- D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: A
NEW QUESTION 12
......
100% Valid and Newest Version NSE7_SDW-6.4 Questions & Answers shared by Certshared, Get Full Dumps HERE: https://www.certshared.com/exam/NSE7_SDW-6.4/ (New 80 Q&As)